Operational Amplifier Testing Module Board OP AMP Tester High Low Speed Differential for Single Chip Dual Quad Channel Electronics Experiments

TEST OBJECT: T2 upgrade OP AMP testing board can be used to test common chips for single OP AMP, double OP AMP and quad OP AMP. The circuit board can determine whether the IC can be used for amplification, and the conversion rate of the chip, can also identify low speed chips that in the of as high speed chips MEASURABLE PARAMETERS: Measurable conversion rate, static current, offset, etc. The distinction between high speed and low speed operational amplifiers is clear, and their performance is immediately apparent. Equipped with test terminals, can test static current OUTPUT MODE: For high speed OP AMP, can output normally when input high and low frequency signal, as the corresponding red LED and green LED synchronization, steady on(200KHZ) or bright (10HZ) Item Type: Operational Amplifier Testing Module Board Material: PCB Size: Approx. 9.5x5.8cm Celsius 3.74x2.28in Power Supply Requirements(2 modes, you can choose one of them according to the actual situation): 1. Wiring : Current: 100mA 2. Use A Regular Monitoring Power Supply: 1A power adapter, plug approx. 5.5 x 2.5mm Celsius 0.22 x 0.1in , positive inside and negative outside. Application: For Single OP AMP Model: LM741, LF356, NE5534, TL071, TL081, 0P07 and other standard single OP AMP packages For Double OP AMP Model: LM358, NE5532, TL072, TL082, MC1458, RC4558, 0P275, AD827 and other standard double OP AMP packages For Quad OP AMP Model: LM324, TL074, TL084, LF347, AD713