High-concerned chemical : none
Remover Type : Gel Remover
Origin : China
feature 1 : Gel Glue Remover
feature 2 : Quick Drying
feature 3 : Cleaner
feature 4 : Super Glue Remover
feature 5 : Adhesive Superglue Cleaner
How to Remove Nail Art and False Eyelash Glue:
1. Apply the glue remover around the nail tip and inside the nail.
2. Wait a while, then use a toothpick or cuticle pusher to gently pry along the nail edge until the remover penetrates into the gaps.
3. Use a cotton swab dipped in the liquid to seep into the nail crevices. Wait a while for the nail glue to dissolve, then gently peel off the nail tip.
4. After removing the nail tip, there may be glue residue around the nail. This can be removed with nail polish remover or nail polish remover wipes. A cuticle oil treatment is also necessary.
[Note: This product does not remove nail art immediately upon application. It needs to be applied gradually while allowing the glue to dissolve, and then gently pried off. Removing the entire set of nail art takes about half an hour.]
5. To remove false eyelashes, brush the remover onto the glued area. Wait a while for the liquid to fully break down the glue, then pull it off easily.
6. If you accidentally get glue on rhinestones while DIY, making them dirty and dull, gently brush the surface with this brush to immediately restore their shine.
Instructions for Correct Adhesive Removal
1. Slightly corrodes some plastics (ABS) and printed inks on products. Please test the product before use.
2. When removing UV adhesive and AB adhesive, allow the adhesive remover to fully contact the adhesive layer for 2-10 hours. Immerse the bonded products in the remover; the adhesive layer will gradually soften and be removed. Do not soak plastic products, as this will dissolve the plastic!
3. It is recommended to test on a small area before using the remover on a larger area.
4. The remover can only remove a small amount of adhesive at a time. If the adhesive is thick or the area is large, repeat the above steps multiple times.
5. The removal speed depends on the thickness and area of the adhesive layer.
Notice:
1. Keep out of reach of children. Use in a well-ventilated area. Those with allergies should wear a mask.
2. When removing products from refrigerated environments, allow the adhesive to reach room temperature before use.
3. The bonding surfaces must be clean and free of contaminants such as oil, dirt, lubricant, and grease.
4. Wear gloves when using to avoid skin splatter. Soak skin in warm soapy water and gently peel off any adhesive residue by hand. Do not use knives or sharp objects to peel it off. If it gets into eyes, rinse immediately with water and seek medical attention.
5. The optimal temperature for greenhouse use is 20℃-30℃.
After applying the adhesive, immediately close the lid tightly to prevent the adhesive from hardening due to prolonged contact with air.
Use in a well-ventilated environment.
Warm Tips:The product is for thermal measurement and may have errors. The actual product shall prevail.
This product is not recommended for surfaces that show color fading, as it may cause color bleeding. It works very well on non-fading adhesive stains on tiled walls. For thick adhesive residue, it is recommended to remove it with a utility knife before using this product.
No-delivery refund
